 |
Safety Tips for
Driving with a Trailer
|
Take time to practice before driving on main roads and
never allow anyone to ride in or on the trailer. Before you leave, remember to
check routes and restrictions on bridges and tunnels. Consider the following
safety tips each time you drive with a trailer.
General Handling
- Use the driving gear that the manufacturer recommends for towing.
- Drive at moderate speeds. This will place less strain on your tow vehicle
and trailer. Trailer instability (sway) is more likely to occur as speed
increases.
- Avoid sudden stops and starts that can cause skidding, sliding, or
jackknifing.
- Avoid sudden steering maneuvers that might create sway or undue side force
on the trailer.
- Slow down when traveling over bumpy roads, railroad crossings, and
ditches.
- Make wider turns at curves and corners. Because your trailer’s wheels
are closer to the inside of a turn than the wheels of your tow vehicle, they
are more likely to hit or ride up over curbs.
- To control swaying caused by air pressure changes and wind buffeting when
larger vehicles pass from either direction, release the accelerator pedal to
slow down and keep a firm grip on the steering wheel.
Braking
- Allow considerably more distance for stopping.
- If you have an electric trailer brake controller and excessive sway
occurs, activate the trailer brake controller by hand. Do not attempt to
control trailer sway by applying the tow vehicle brakes; this will generally
make the sway worse.
- Always anticipate the need to slow down. To reduce speed, shift to a lower
gear and press the brakes lightly.
Acceleration and Passing
- When passing a slower vehicle or changing lanes, signal well in advance
and make sure you allow extra distance to clear the vehicle before you pull
back into the lane.
- Pass on level terrain with plenty of clearance. Avoid passing on steep
upgrades or downgrades.
- If necessary, downshift for improved acceleration or speed maintenance.
- When passing on narrow roads, be careful not to go onto a soft shoulder.
This could cause your trailer to jackknife or go out of control.
Downgrades and Upgrades
- Downshift to assist with braking on downgrades and to add power for
climbing hills.
- On long downgrades, apply brakes at intervals to keep speed in check.
Never leave brakes on for extended periods of time or they may overheat.
- Some tow vehicles have specifically calibrated transmission tow-modes. Be
sure to use the tow-mode recommended by the manufacturer.
Backing Up
- Put your hand at the bottom of the steering wheel. To turn left, move your
hand left. To turn right, move your hand right. Back up slowly. Because
mirrors cannot provide all of the visibility you may need when backing up,
have someone outside at the rear of the trailer to guide you, whenever
possible.
- Use slight movements of the steering wheel to adjust direction.
Exaggerated movements will cause greater movement of the trailer. If you
have difficulty, pull forward and realign the tow vehicle and trailer and
start again.
Parking
- Try to avoid parking on grades. If possible, have someone outside to guide
you as you park. Once stopped, but before shifting into Park, have someone
place blocks on the downhill side of the trailer wheels. Apply the parking
brake, shift into Park, and then remove your foot from the brake pedal.
Following this parking sequence is important to make sure your vehicle does
not become locked in Park because of extra load on the transmission. For
manual transmissions, apply the parking brake and then turn the vehicle off
in either first or reverse gear.
- When uncoupling a trailer, place blocks at the front and rear of the
trailer tires to ensure that the trailer does not roll away when the
coupling is released.
- An unbalanced load may cause the tongue to suddenly rotate upward;
therefore, before un-coupling, place jack stands under the rear of the
trailer to prevent injury.
Back
| Table of Contents |
Next
|